Disconnect The Ballast. Now you’ll need to disconnect all wires from the existing ballasts. Make sure to keep track of which wire goes where to ensure proper rewiring later on. Remove the ballast (if you wish) once you have disconnected the ballast from its wires by cutting. Whether you're upgrading to led lighting. Now that you have severed the wires that create the circuit through the ballast, you can unscrew the ballast and physically remove it or. changing over a fluorescent light fixture to led bulbs and removing ballast Another good tip is to photograph the wiring setup before you start so that you can refer back to it when rewiring. you don’t need to remove the ballast to use led tube lights, provided you buy plug and play led tubes that are designed to work in a ballasted socket. first, turn off the power at your circuit breaker and unscrew or loosen the screws to remove the outer light housing.
from www.grainger.com
Now that you have severed the wires that create the circuit through the ballast, you can unscrew the ballast and physically remove it or. Now you’ll need to disconnect all wires from the existing ballasts. first, turn off the power at your circuit breaker and unscrew or loosen the screws to remove the outer light housing. Another good tip is to photograph the wiring setup before you start so that you can refer back to it when rewiring. you don’t need to remove the ballast to use led tube lights, provided you buy plug and play led tubes that are designed to work in a ballasted socket. Remove the ballast (if you wish) once you have disconnected the ballast from its wires by cutting. Whether you're upgrading to led lighting. changing over a fluorescent light fixture to led bulbs and removing ballast Make sure to keep track of which wire goes where to ensure proper rewiring later on.
Disconnect The Ballast changing over a fluorescent light fixture to led bulbs and removing ballast changing over a fluorescent light fixture to led bulbs and removing ballast Make sure to keep track of which wire goes where to ensure proper rewiring later on. you don’t need to remove the ballast to use led tube lights, provided you buy plug and play led tubes that are designed to work in a ballasted socket. Now that you have severed the wires that create the circuit through the ballast, you can unscrew the ballast and physically remove it or. first, turn off the power at your circuit breaker and unscrew or loosen the screws to remove the outer light housing. Now you’ll need to disconnect all wires from the existing ballasts. Whether you're upgrading to led lighting. Another good tip is to photograph the wiring setup before you start so that you can refer back to it when rewiring. Remove the ballast (if you wish) once you have disconnected the ballast from its wires by cutting.
